Nissan R34 Front Drift Angle Lock Kit

$2,400.00
excluding VAT
In stock
SKU
WF340
or View Spares

Nissan Skyline R33 Angle kit has the OEM upper control arms replaced with Wisefab upper control arms for better kinematics and to avoid rubbing issues at full lock. Knuckle has Ackermann adjustment built in. Adjusting Ackermann setup you can achive maximum sideways grip. Lower control arms are suitable for S and R-Chassis. The new lower control arms are easy to adjust. All the metal components on Wisefab Nissan Skyline R33 front suspension are from high strength steel, including sheetmetal components, tube ends and rod end housings. Rod ends and spherical bearings are used, no rubber bushings. 

Want to know how does Wisefab Lock kit fits your driftcar check below the link CHECK FITMENT or here!

Scroll down to order your spare parts conviently right here!

Here is our recommended alignment parameters:
Toe in/out: If Ackermann is 0 or negative then toe is 2mm out. If Ackermann is positive then toe is 0
Camber: -4,5 +/-0,5
Caster: 4,3 +/-0,5

By installing Nissan S14 rear subframe to your Nissan Skyline you can install the Wisefab Nissan S14 Rear Suspension kit. to your Nissan Skyline

  • 65 degrees of lock, parallel steering.
    You can tune your steering geometry either towards positive or negative Ackermann in just a few minutes even at trackside without messing up an alignment. 
    Ackermann adjustment kit included.
  • Adjustable lock stopper.
  • One piece design.
    Lower 2 piece arm is replaced with one piece design to increase system stiffness that is needed for high lock.
  • Higher roll center (RC).
    On Wisefab Nissan R-chassis knuckle, both joints are dropped, which brings the front RC up on lowered car, providing higher roll and better camber gain.
  • Very good camber control and minimal bump steer with high steering angles
    On drift cars the dynamic camber and bump steer is much more important than static. With Wisefab kinematics we have assured that the camber would provide very good front grip and bump steer is minimal at all the range of steering.
  • Steering jacking control. 
    During drifting, when steering angle is much bigger, jacking is also bigger, even with the same geometry and it could become a problem. We have changed the geometry so that it doesn't cause any handling issues.
  • Consistent and predictable self-alignment torque. 
    Caster is not the only important parameter to provide sufficient self-alignment torque especially at high lock. It's the combination of different parameters to maintain consistent trail and self-alignment torque. With our setup the steering wheel turns always to the direction of movement and doesn't get stuck at full lock.

Kit includes:

  • Pre-set upper and lower control arms.
  • Knuckles with hardware.
  • Assembeled tie rods.
  • Installation guide.

 

Other components, packaging and clearance.

  • Requires S14 hubs.
  • This kit assumes car to have coilovers to have enough clearance.
  • Ride height is designed to be ~80mm from front subframe to ground.
  • Dependent on rim width and ET, wider fenders or fender flares would be needed.
  • Inner wheel wells do not need to be modified with tire diameter up to 635mm (225/45R17, 235/40R17, 235/35R18, 255/30R18 etc).
  • Minimum rim diameter is 17".
  • Recommended backspacing is ~135mm (7" ET45; 8" ET35; 9" ET20). If ET is smaller, then wheels stay more outwards, if ET is bigger, then spacers need to be used.
  • The kit is designed and manufactured the way that after installation and toe adjustment it's ready to use right away.
More Information
Make Nissan
Field Drift
Placement Front
Prodmaster Name Drift Angle Lock Kit
Wisefab fitment calculator
Make and Model
?
Fender Arch Height from Ground (mm)
Tire Width
Tire Height or Diameter
Rim Diameter
Rim Width
ET
Wheelspacer (mm)
Suspension selection
Suspension selection
OEM
WISEFAB
CUSTOM
 
1785 mm
1785 mm
Fender to Fender
1548 mm
1695 mm
Hub to Hub
-2 °
-4 °
Camber
6 °
4 °
Caster
0 mm
-2 mm
Toe

Set your desired rim and tire parameters in our fitment calculator to have a better overview how Wisefab will transform your driftcar. Fender arch height is your indicator on ride height. Check the fitment and learn about missing fender gap before ordering widebody kit. In the custom section you can edit the fender to fender and wheelhub to wheelhub measurments according to your driftcar. Use the max width to check if your car will fit on your trailer. Have fun with this fitment calculator.

Spare parts

All
Complete parts
Left Knuckle
Right Knuckle
V2 Lower Control Arm
Left Upper Control Arm
Right Upper Control Arm
Tie Rod Assembly

Complete parts

Complete parts

1
Knuckle
Left
WF340_100LA
$465.00
excluding VAT
Right
WF340_100RA
$465.00
excluding VAT
2
V2 Lower Control Arm
WF140_200A
$500.00
excluding VAT
3
Upper Control Arm
Left
WF330_300LA
$355.00
excluding VAT
Right
WF330_300RA
$355.00
excluding VAT
4
Tie Rod Assembly
WF340_600A
$150.00
excluding VAT

Left Knuckle

Left Knuckle

2
Bolt Hex M10x1.5x 65 RH 10.9 ST DIN 931
B01110150065R3SD931
$4.30
excluding VAT
3
Ackermann Washer Round 0 offset
WF013_140
$11.00
excluding VAT
4
Ackermann Washer Round 3 Offset
WF080_142
$11.00
excluding VAT
5
Ackermann Washer Round 6 Offset
WF080_144
$11.00
excluding VAT
6
Nut Nylock M10x1.5 RH 8.8 ZN DIN985-8
B02210150R2ZD9858
$2.30
excluding VAT
7
Bolt Hex M 8x1.25x 55 RH 8.8 ZN DIN 931
B01108125055R2ZD931
$2.30
excluding VAT
8
BushingT ID 8 OD22 h41 Excentric Lock Stopper
WF350_950
$18.00
excluding VAT
9
Bolt Hex M12x1.5x 60 RH 10.9 ST DIN 960
B01112150060R3SD960
$6.40
excluding VAT
10
Washer FlatSmall M12 ZN DIN433
B03212NAZD433
$2.30
excluding VAT

Right Knuckle

Right Knuckle

2
Bolt Hex M10x1.5x 65 RH 10.9 ST DIN 931
B01110150065R3SD931
$4.30
excluding VAT
3
Ackermann Washer Round 0 offset
WF013_140
$11.00
excluding VAT
4
Ackermann Washer Round 3 Offset
WF080_142
$11.00
excluding VAT
5
Ackermann Washer Round 6 Offset
WF080_144
$11.00
excluding VAT
6
Nut Nylock M10x1.5 RH 8.8 ZN DIN985-8
B02210150R2ZD9858
$2.30
excluding VAT
7
Bolt Hex M 8x1.25x 55 RH 8.8 ZN DIN 931
B01108125055R2ZD931
$2.30
excluding VAT
8
BushingT ID 8 OD22 h41 Excentric Lock Stopper
WF350_950
$18.00
excluding VAT
9
Bolt Hex M12x1.5x 60 RH 10.9 ST DIN 960
B01112150060R3SD960
$6.40
excluding VAT
10
Washer FlatSmall M12 ZN DIN433
B03212NAZD433
$2.30
excluding VAT

V2 Lower Control Arm

V2 Lower Control Arm

2
V2 Lower Control Arm Fixing
WF140_210A
$140.00
excluding VAT
3
Spacer ID14 OD16 h21
WF013_902
$13.00
excluding VAT
4
Rod end 16x1.5 RH male CrMo
SRODEND16X1.5 RH M
$39.00
excluding VAT
5
Nut Thin M16x1.5 RH 8.8 ZN DIN936/439
B02316150R2ZD936/439
$4.30
excluding VAT
6
Spacer ID12 OD16 h10
WF013_903
$13.00
excluding VAT
7
C-Clip InternalSTD d32 ST DIN472
B04132SD472
$2.30
excluding VAT
8
Spherical ID16/OD32
SSPHERICAL 16/32
$38.00
excluding VAT

Left Upper Control Arm

Left Upper Control Arm

2
Spacer ID12 OD16 h11.9
WF113_903
$13.00
excluding VAT
3
Rod end 16x1.5 RH male CrMo
SRODEND16X1.5 RH M
$39.00
excluding VAT
4
Nut Thin M16x1.5 RH 8.8 ZN DIN936/439
B02316150R2ZD936/439
$4.30
excluding VAT
5
BushingT ID12.5 OD26 h103
WF330_904
$18.00
excluding VAT
6
BushingPOM ID26 OD40 h45
WF330_905
$16.00
excluding VAT

Right Upper Control Arm

Right Upper Control Arm

2
Spacer ID12 OD16 h11.9
WF113_903
$13.00
excluding VAT
3
Rod end 16x1.5 RH male CrMo
SRODEND16X1.5 RH M
$39.00
excluding VAT
4
Nut Thin M16x1.5 RH 8.8 ZN DIN936/439
B02316150R2ZD936/439
$4.30
excluding VAT
5
BushingT ID12.5 OD26 h103
WF330_904
$18.00
excluding VAT
6
BushingPOM ID26 OD40 h45
WF330_905
$16.00
excluding VAT

Tie Rod Assembly

Tie Rod Assembly

3
Bolt Allen M16x1.0x 30 RH 12.9 ZN D912
WF013_913
$20.00
excluding VAT
4
Tie Rod Inner M14x1.5 M14x1.5 L360
STIEROD_M14_M14_L360
$31.00
excluding VAT
5
Spacer ID10 OD14 h11
WF013_901
$11.00
excluding VAT
6
Rod end 14x1.5 RH female CrMo
SRODEND14X1.5 RH F
$39.00
excluding VAT
Wisefab Nissan 240sx
"’We started working together with Wisefab back in 2014 when we launched our Falken Tyres Nissan 240sx for European competition. Since then, we have enjoyed working closely with the engineers at Wisefab testing new products before going into production and have had a lot of success winning multiple championship worldwide. Thank you to everyone at Wisefab for believing in us and producing such top-quality products."
Nissan 240sx Drift
“When I first installed a Wisefab lock kit it truly opened the door for some more aggressive driving style. I quickly began to expect nothing less than the massive angle and performance that Wisefab provides and installed a lock kit on all (4) of my Nissan 240sx that I currently drift. Also, after testing what I though was a very competitive rear suspension solution against the latest Wisefab rear kit, I was blown away with the apparent grip gain the rear Wisefab kit yielded. I am so thankful that Wisefab has poured so much effort into creating a bolt on suspension solution that transforms a Nissan 240sx into what I believe is still the most competitive drift chassis in the world."
Nissan 240sx Lock kit
"I love the Wisefab suspension kits used on my competition and demo vehicles, they provide all the angle and grip we love along with the strength and durability we need to compete with the best!"
Toyota 86 Drift
"I wouldn't have half the results! Only by running Wisefab in my Toyota 86 it just makes the car handle so good and let's me adjust set up pretty easy which is a massive help going from track to track!"